[Sticky] DRAGONPHARMASTEROIDS.COM

yea i am pretty lean i just sit up on my bed and put my leg out straight i was scared as hell the first few times but havent nocked a vein or even a nerve, glutes suck doing them on ur own and delts build up scar tissue quickly

I just grabbed some 1/2" 29g insulin pins today for test and tren prop. 1/2" is so short that I think my quads are the only place it will work so we'll see. I've never used tren prop so I'm not sure if it will go through a 29g but daily injects with 23g pins is not what I want to do. Hopefully I get to try soon.

I just grabbed some 1/2" 29g insulin pins today for test and tren prop. 1/2" is so short that I think my quads are the only place it will work so we'll see. I've never used tren prop so I'm not sure if it will go through a 29g but daily injects with 23g pins is not what I want to do. Hopefully I get to try soon.

Why not just get 25g?

Why not just get 25g?

I'm in a country where just getting pins is hard, much less gear. So my options are a bit limited.

Why not just get 25g?

Do you think 29g is too small for tren ace? I have plenty of 3ml, 23g pins but measuring out 75 mg and injecting daily with these with not be preferred. I'll do it if I have to. I know drawing up and injecting with the 29s is going to be a slow ordeal, but can it be done? What I would probably do is sit the vial in some warm water for like 20 minutes to warm up and thin out the oil. Hopefully that will help.

Do you think 29g is too small for Tren Ace? I have plenty of 3ml, 23g pins but measuring out 75 mg and injecting daily with these with not be preferred. I'll do it if I have to. I know drawing up and injecting with the 29s is going to be a slow ordeal, but can it be done? What I would probably do is sit the vial in some warm water for like 20 minutes to warm up and thin out the oil. Hopefully that will help.

Yeah warming it would deff help, just in my preference I would rather the needle be to big than to small, but some people are tripped out by bigger needles.

Yeah warming it would deff help, just in my preference I would rather the needle be to big than to small, but some people are tripped out by bigger needles.

I did a test run with some Tren Enanthate through the 29g pins. Even after warming it up drawing the oil out the normal way would have taken an hour so I drew 75mgs out with a 23g, 3ml pin and backfilled the small one. Kind of a pain in the ass(no pun intended) but once it was in the barrel I didn't have any issues. I didn't even have to push the plunger that much slower. I have skinny ass quads, just a thin layer of skin over muscle so the thin, short(1/2") pins work well there. I'll use them up, but I'm going to see if my supplier can get 25g, 1" next time. Just so I have more options in terms of where to pin.