Notifications
Clear all
Anabolic Steroids & Prohormones
7
Posts
3
Users
0
Reactions
603
Views
Topic starter
29/05/2022 1:34 am
Say a person was using a 50mg/ml Tren oil based injectable and wanted to rotate sites between shoulders, glutes and quads, and wanted to balance .5 ml per side, left and right to keep volume down. Also if there is any sweeling, shoulders , the person would not look lop sided. Does the person have to get a new syringe along with pin, or would the pin be able to be changed and the same syringe be used?
Would this person be able to use a 25 gauge pin to reduce the soreness of the injection site if it was injected slowly, like around 30-60sec.
How about gaudge length, the person was thinkning 1.5in for glutes and 1in for shoulders and quads.
What are some opinions.
29/05/2022 2:05 am
yes, darko, everything you said for that person sounds right.... 😀
but I'm not 100% sure tren will go thru a 25gauge pin.....but I think it will.
Topic starter
29/05/2022 2:30 am
Thanks a lot bro, anyone ever tried 25gauge for oil based?
29/05/2022 2:48 am
25g x 1" is what I use, it works very well. Just take your time. You could change the viscosity by letting the pin sit in a cup of warm water for a minute or so.
Topic starter
29/05/2022 3:17 am
Thanks bro, I will pass that on
29/05/2022 3:36 am
Glad to help, bro.
29/05/2022 3:57 am
good call 'cardi, I forgot about heating the oil to make it flow better.
my horse has gotten used to the 22gaugers, so its not necessary with those.... 😀